Open the phone just enough to reveal the metal bracket covering the home button cable. Do not open the phone too far or you risk damaging the home button cable, or the socket it plugs into. Keep the cable loose—if it is stretched taut, that's too far. Only the phone's original home button assembly will be capable of using the Touch ID functionality. If you rip the cable, installing a new home button will only restore ordinary home button functions, not the Touch ID features.

The next two steps apply to reassembly.

Skip them and continue to Step 12 until reassembly. During reassembly, you will need to reinstall the Touch ID cable bracket. The top of the bracket needs to slide between the battery and Touch ID cable connector, in front of the metal tab. The bottom must latch down over the connector. Slide the top of the bracket over the Touch ID cable connector from left to right. Use the flat end of a spudger to snap the front portion of the Touch ID cable bracket down over the cable connector. If the bracket does not snap down flush, you may need to remove the bracket and slide it over the cable connector again for a better fit.

Use the tip of a spudger to pry the home button cable connector up out of its socket. Be sure you're separating the cable connector from its socket, and not prying the entire socket up. The socket is on its own glued-down cable that can be pried up if you aren't careful. Once the connector has been released, pull the home button end of the assembly away from the rear case, using the top of the phone as a hinge.

Add a rubber band to keep the display securely in place while you work. This prevents undue strain on the display cables. Remove the two 1. Use the flat end of a spudger to gently pry the battery connector up from its socket on the logic board. Be very careful to only pry up on the battery connector itself and not the socket on the logic board. If you pry up on the logic board socket or the board itself, you may destroy the socket or damage nearby components on the board. Remove the following screws securing the front panel assembly cable bracket to the logic board:.

This 1. Take care not to lose it when removing. It is especially important to keep track of your screws in this step for reassembly. Accidentally using the 1. Be careful not to over-tighten the screws, and don't force them. If they don't fit easily when you are securing them, they may be the wrong size. Use a spudger or a fingernail to disconnect the front-facing camera and sensor cable. Make sure the battery is disconnected before you disconnect or reconnect the cable in this step. When reassembling your phone, the LCD cable may pop off the connector.

This can result in white lines or a blank screen when powering your phone back on. If that happens, simply reconnect the cable and power cycle your phone. The best way to power cycle your phone is to disconnect and reconnect the battery. Run the tip of a spudger between the battery and the headphone jack to unfold the battery adhesive tab. Apply heat to the bottom of the iPhone case using an iOpener or similar heating pad to soften up the battery adhesive strips and make them more flexible, otherwise they will probably break when you pull on them.

Cut the black battery adhesive tab between the two white adhesive strips, separating them.

Try to keep the strips flat and unwrinkled during this procedure; wrinkled strips will stick together and break instead of pulling out cleanly. Slowly pull one of the battery adhesive strips away from the battery, toward the bottom of the iPhone. Pull the white portion of the strip when possible, the black tab may fall off. Pull steadily, maintaining constant tension on the strip as it slips out from between the battery and the rear case.

The strip will stretch to many times its original length. Continue pulling, re-grabbing the strip near the battery if necessary, until the entire strip comes free. If either of the adhesive strips break underneath the battery and cannot be retrieved, try to remove the remaining strip, and then proceed to the next step. If any of the adhesive strips broke off and the battery remains stuck to the rear case, prepare an iOpener or use a hair dryer to heat the rear case directly behind the battery.

Flip the iPhone back over and insert a plastic card between the case side of the battery and the rear case. Avoid prying at the top left near the volume controls, or you may damage the volume button ribbon cable. Keep the card as flat as possible to avoid bending the battery, which may damage it and cause it to release dangerous chemicals or catch fire. Do not use any sharp tools to pry at the battery. Alternatively, a piece of dental floss may be used to separate the battery from the rear case.

A stronger alternative to dental floss is an unwound guitar string, such as a 0.

iFixit Store Europe | iPhone 5s Replacement Battery

Thread the floss or string behind the upper battery corners, bring the ends together, wrap them around a folded cloth, and pull evenly. If your replacement battery came in a plastic sleeve, remove the sleeve before installation by pulling it away from the ribbon cable. When installing the battery, refer to this guide to replace your battery's adhesive strips. Perform a hard reset after reassembly. This can prevent several issues and simplify troubleshooting. Compare your new replacement part to the original part—you may need to transfer remaining components or remove adhesive backings from the new part before installing.

Take your e-waste to an R2 or e-Stewards certified recycler. Check out our Answers community for troubleshooting help. I did not complete this guide. If the adhesive breaks without releasing, and you need to use a spudger or similiar to remove the battery, be VERY careful not to damage the Upper Component Cable. This should've been included in the repair guide, as the adhesive tabs seemed designed to break.

My phone is now in worse shape than it was and I'm facing what seems to be an extremely difficult repair, which I will probably not undertake. I did not get all of the adhesive out from under the battery. A mention of whether it would be safe would be nice. I found it impossible to get the clip from step 7 back on.

I left it off. If there's a trick to this, it would be nice to have that extra instruction with the reassembly instructions, rather than "reverse order. While this is always a good idea, in the process of trying to get something done, it's easy to forget that you need to remember which screws go back where, especially the 3 different-sized screws from step What an evil thing Apple did there! I laid the bracket upside-down on a piece of tape, and oriented the screws around it so I'd know where they go back upon reassembly a week later.

A suggestion of doing something like this might be helpful.

Video Overview

With regards to the bent battery, you were right to replace it. LiOn Batteries are very dangerous when the cells inside are compromised. Even though the good ones have circuit breakers built in to prevent fire, they can fail. A LiOn battery - even a small one in an iPhone - can go "high order" and cause a fire that is next to impossible to extinguish.

The way I keep track of screws Get a complete set of all colors of Sharpie pens. When disassembling, I touch the screw head with the same color pen as the circle in the iFixit Guide. Select a Language: Help Translate iFixit. Additionally, these older batteries cannot offer the same peak power at those times where it is required, meaning that things slow down or behave aberrantly. Could make a world of difference, allow you to learn a new skill, and save you some dosh. My zip code: My iPhone 5s just shut down. It had not been dropped or anything.

Even when I plug it in to the charger, it will not turn on. Please advise me on this. Thank you for your assistance!

This is the best case i have every had for an iphone 4s. I am so pleased!! Appreciate it! The Video Show Module VDM maks the first implementation of a reminiscence-mapped alphanuimeric video show for private computer systems.

• How to replace the battery in your iPhone 5s - iFixit Repair Guide!
• google map for android phone free download.
• appsync ios 5 x repo?
• nintendo 3ds emulator android download free.
• metal gear solid mobile download java;

Very true. But iPhone 5 users will be delighted to know that that an Apple Authorized Service Provider has communicated about replacing the old iPhone 5 with a new iPhone 5 contract free at the cost of replacing the battery of iPhone 5. Provided the old iPhone 5 has no external physical damage, not opened and repaired by unauthorized person and no damage by water. The screens are both good though. Is it too late for the ifixit offer now? Because I could also use a battery kit for a third iPhone 5S which is actually the most worn out.

Thanks, Kevin. Your email address will not be published.

iPhone 5s Replacement Battery

Search Search for: No need to drive anywhere or wait in line; replace your battery from your kitchen. Paul December 28, at 6: Jefferson Mixell December 29, at 5: Samsung2Apple December 29, at 6: Steve Sagan Jobs December 29, at 6: I have seen no mention of that by Apple or in any of the stories about all this! Anyone know?! Kyle Wiens December 29, at 8: Thanks iFixIt! For the tech savvy consumer, the DIY option is still available. Phil Sullivan December 29, at Kyle Wiens December 29, at Zap B.

Samsung's Galaxy S10 provides a sneak peek at WiFi's future

December 29, at 1: Dan Kallal December 29, at 1: Kyle Wiens December 29, at 3: Adam Fullerton December 29, at 5: Waqas Ahmad December 30, at Rene G. January 2, at Where does that model fit into the mix? Kyle Wiens January 2, at Curious George January 3, at 8: Sue Usher January 4, at 9: James Kullman January 9, at Bill January 9, at 1: Crapple January 13, at Janu January 19, at 9: Julia Bluff January 21, at 2: Jim January 31, at 5: Jill February 7, at 4: Nathan James May 8, at 8: Nathan James May 10, at 5: Anthony June 4, at Catherine Finch June 5, at 6: Jimmie H.

Kingbrion July 6, at 1: Patrick July 10, at Ignacio August 13, at 3: Andrew Schulman September 13, at 8: Kevin Moorman January 3, at 4: Mick Connaughton January 26, at 7: Leave a Reply Cancel reply Your email address will not be published. Repair is noble.